Industrial Sliding Gate

We Are Available For You

Industrial Sliding Gate

Industrial Sliding Gates by Rudhar Group
Get Best Quote
  • Rudhar Gates designed and fabricated with special square or rectangular hollow          sections, along with MS sheets and flats assembled by high qualitywelding.
  • Gates are aesthetically pleasing and the pre-tensioning of the gate leaf fabrication          reduces the risk of bending.
  • Variousrange of models for gates weighing from 300 kg to 8000kg.
  • Single phase electronic (230 V) & Three phase electronic (400 V) ensures maximum          performances even under adverse conditions, thanks to greater dynamic Torqueduring        the initial phase ofoperation.
  • Mechanical sensitivity detection causes the gate movement to stop if an obstacle is          detected.
  • Hi-Tech electronic control unit permits operation time adjustment, partial opening,          automatic closing, step by step control, stop safety, reverse safety etc

Related Gate Solutions

Frequently Asked Questions

What is an industrial sliding gate?

An industrial sliding gate is a heavy-duty automated gate that slides horizontally to secure large industrial and commercial entrances, built for durability and frequent use.

What are its advantages?

It handles wide openings, offers strong security, operates automatically via remote or access control, and is built for heavy, frequent industrial use.

Where is it used?

Factories, warehouses, logistics parks, industrial estates and large commercial premises needing secure, automated vehicle access.

What is the price?

The price depends on width, height, material and automation. Share your requirements for a free quote.

Is it available in Delhi NCR?

Rudhar Group has been manufacturing and installing across Delhi NCR — Delhi, Gurugram, Noida, Faridabad, Ghaziabad and Bahadurgarh — and all over India since 1998.

Service Area

Rudhar Group manufactures at our facility in Delhi NCR and supplies Industrial Sliding Gate across North India — Delhi NCR, Haryana, Punjab, Himachal Pradesh, Jammu & Kashmir, Uttar Pradesh, Madhya Pradesh and Rajasthan. Manufacturing has been running since 1998.

Each unit is manufactured to the opening size supplied by the buyer, so share your site dimensions and location for a quotation. Site survey and installation support are arranged for projects across the states listed above.

Frequently Asked Questions

Common questions answered by our technical team.

Industrial sliding gates are used at factory entrances, warehouse compounds, power plants, logistics depots, and large commercial premises where a heavy-duty, secure, high-frequency gate is required to handle daily operation by heavy vehicles.

Rudhar Group specifies motors based on gate leaf weight. Standard industrial sliding gate motors handle gate leaves of up to 500 kg, 1000 kg, and 2000 kg depending on the model. Gate weight is calculated based on frame dimensions, infill panel material, and gate height.

Industrial sliding gates run on a flat or V-groove ground track with heavy-duty bottom wheels made from steel or nylon with steel bearings. The top is guided by upper guide brackets fixed to a secondary track or gate post.

A cantilever sliding gate can be installed without a ground track, supported by a counterbalance frame mounted behind the pillar. This is recommended for unpaved ground, railway crossings, driveways with drains, or sites where a ground track would be a trip hazard.

Standard industrial sliding gates operate at 10-15 cm per second. For a 6-metre wide gate, a full open cycle takes 40-60 seconds. For faster opening with high-frequency truck movements, a telescopic sliding gate is recommended.

Industrial sliding gates from Rudhar Group can be integrated with access control keypads, RFID card readers, loop detectors, intercom systems, CCTV camera mounts, traffic lights, electric locks, and remote management systems.

© 2026 Rudhar Group. All Rights Reserved.

Crafted with by Graphic Word - Web Designing, Digital Marketing & Branding Company
Get a Quote